- About This Guide
- Notes, Cautions, and Warnings
- Introduction
- Deployment Prerequisites
- Install and Connect the FS8600 Hardware
- Configure the
FluidFS Cluster
- Configure FluidFS Cluster Network Settings
- Connect to the FluidFS Cluster CLI
- Configure Cluster IP Addresses and the Default Gateway
- Use Dell Storage
Manager to Configure the FluidFS Cluster
- Prerequisites
- Log In to Dell Storage Manager
- Add the FluidFS Cluster to Dell Storage Manager
- Select Appliances
- Configure the Client Network
- Configure the Default Gateway
- Configure DNS Settings
- Configure Time Settings
- Select Storage Centers
- Configure Fibre Channel SAN Connectivity
- Configure iSCSI SAN Connectivity
- Finalize FluidFS Cluster Configuration
- Remove a FluidFS Cluster From Dell Storage Manager
- Configure FluidFS Cluster Network Settings
- Perform Post-Setup Tasks
- Upgrade an Appliance to the Latest FluidFS 6.0 Version
- iSCSI Switch Configuration Examples
Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide
Record FluidFS World Wide Names
Use the Connectivity Report page to record the World Wide Name (WWN) for each FluidFS Fibre Channel port.
To verify connectivity between the FluidFS cluster and the Storage Center, use the Connectivity Report page. The NAS controller ports must show the status as Up before you can complete the wizard. if you click Finish and the NAS controller ports do not have the Up status, an error is displayed.
Oppgi vurderinger (1–5 stjerner).
Oppgi vurderinger (1–5 stjerner).
Oppgi vurderinger (1–5 stjerner).
Velg om artikkelen var nyttig eller ikke.
Kommentarer kan ikke inneholde disse spesialtegnene: <>()\