- About This Guide
- Notes, Cautions, and Warnings
- Introduction
- Deployment Prerequisites
- Install and Connect the FS8600 Hardware
- Configure the
FluidFS Cluster
- Configure FluidFS Cluster Network Settings
- Connect to the FluidFS Cluster CLI
- Configure Cluster IP Addresses and the Default Gateway
- Use Dell Storage
Manager to Configure the FluidFS Cluster
- Prerequisites
- Log In to Dell Storage Manager
- Add the FluidFS Cluster to Dell Storage Manager
- Select Appliances
- Configure the Client Network
- Configure the Default Gateway
- Configure DNS Settings
- Configure Time Settings
- Select Storage Centers
- Configure Fibre Channel SAN Connectivity
- Configure iSCSI SAN Connectivity
- Finalize FluidFS Cluster Configuration
- Remove a FluidFS Cluster From Dell Storage Manager
- Configure FluidFS Cluster Network Settings
- Perform Post-Setup Tasks
- Upgrade an Appliance to the Latest FluidFS 6.0 Version
- iSCSI Switch Configuration Examples
Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide
Set Support User Password
Use the this page to set the support user password.
Click
Setup FluidFS NAS to reenter the
Add FluidFS Cluster wizard.
The
Set Support User Password page
opens. The support account is used by Dell Technical Support to perform
remote troubleshooting. A password must be set for the support account
even if it is disabled.
- In the Password field, type a password for the support account.
- In the Confirm Password field, retype the password.
- (Optional) Select the Support Access checkbox to enable the support account.
Oppgi vurderinger (1–5 stjerner).
Oppgi vurderinger (1–5 stjerner).
Oppgi vurderinger (1–5 stjerner).
Velg om artikkelen var nyttig eller ikke.
Kommentarer kan ikke inneholde disse spesialtegnene: <>()\