- Notes, cautions, and warnings
- Dell PowerEdge C6320p overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Updating the Fan Control Board firmware
- Prerequisites for installing and removing components
- Installing and removing sled components
- Inside the system
- PowerEdge C6320p sled
- Air shroud
- System memory
- 1.8-inch Solid State Drive
- SATA cable removal and installation for the sled
- Processor and heat sink module
- Removing the fabric cable from the processor
- Connecting the fabric cable to the processor
- Removing the processor and heat sink module
- Installing the processor and heat sink module
- Removing the fabric processor from the processor heat sink module
- Installing the fabric processor into the processor heat sink module
- Removing the non fabric processor from the processor heat sink module
- Installing the non fabric processor into the processor and heat sink module
- Expansion card assembly and expansion card
- PCIe slot priority
- Removing the expansion card riser assembly
- Installing the expansion card riser assembly
- Removing an expansion card
- Installing an expansion card
- Removing the riser card
- Installing the riser card
- Removing the cables from the fabric carrier card
- Connecting the cables to the fabric carrier card
- Mezzanine cards and mezzanine bridge card
- System battery
- Trusted Platform Module
- System board
- SAS connector protector
- Installing and removing enclosure components
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial input and output device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting cooling problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting a micro SD card
- Troubleshooting a drive or SSD
- Troubleshooting expansion cards
- Troubleshooting processors
- System messages
- Getting help
Dell PowerEdge C6320p Owner's Manual
Dell PowerEdge C6320p overview
The Dell PowerEdge C6300 is an ultra-dense 2U enclosure that can support up to four independent single-socket (1S) sleds connected to a direct backplane that supports twenty four 2.5-inch hard drives and two hot plug power supply units. Each PowerEdge C6320p sled has the following features:
- Each sled features an Intel Xeon Phi 72XX or 72XXF processor with 64, 68, or 72 cores
- Each processor features a 16 GB MCDIMM
- Support for up to six DDR4 LRDIMM or RDIMM memory modules
- Each sled supports six 2.5-inch hard drives or Solid State Drives.
- Intel C612 chipset for I/O connectivity
- Each sled has the integrated iDRAC8 express systems management with a dedicated RJ45 management port
- Each sled has an embedded 1 Gigabit Ethernet controller (RJ45)
- Optional integrated Mellanox ConnectX-4 VPI EDR / 100 GbE Port
WARNING: Sleds using the Intel Xeon Phi 72XX and Phi 72XXF processors must
not be installed in the same enclosure.
NOTE: Mixing the PowerEdge
C6320 and PowerEdge C6320p sleds in the same PowerEdge C6300 enclosure
is not supported.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\