There is a high probability that the i7-6970 HQ is suitable.
The 2016 15 R3 was never validated with the i7-6970 HQ. These were the best we validated = Intel i7-6820 HK Skylake, 8MB SmartCache, 2.7GHz up to 3.6GHz Intel i7-7820 HK Kaby Lake, 8MB SmartCache, 2.9GHz up to 3.9GHz
The CPU in that model cannot be removed or changed, as it is soldered onto the motherboard. You would have to replace the entire motherboard, and the cost would be quite prohibitive. The following forum post addresses that same question.
То есть в теории если сделать все правильно и аккуратно, то есть большая вероятность, что эти два процессора заработают, в совокупности с данным комплектом микросхем?
Благодарю, пока что это теоретический вопрос для меня, закончу один проект, и возможно попробую на практике, все же риск велик, плату может погнуть температура или возникнет проблема с СМД компонентами. Пока что рисковать своей "рабочей лошадкой" не хочется.
I never considered that you would actually solder in a new processor. Obviously you have access to equipment and skills that the average user does not possess. My compliments to you!
RokotOn
5 Posts
0
February 20th, 2019 06:00
There is a high probability that the i7-6970 HQ is suitable.
The 2016 15 R3 was never validated with the i7-6970 HQ. These were the best we validated =
Intel i7-6820 HK Skylake, 8MB SmartCache, 2.7GHz up to 3.6GHz
Intel i7-7820 HK Kaby Lake, 8MB SmartCache, 2.9GHz up to 3.9GHz
JOcean
9 Legend
9 Legend
•
12.2K Posts
1
February 20th, 2019 05:00
The CPU in that model cannot be removed or changed, as it is soldered onto the motherboard. You would have to replace the entire motherboard, and the cost would be quite prohibitive. The following forum post addresses that same question.
https://www.dell.com/community/Alienware/Upgrade-Alienware-15-R3-CPU/td-p/6217250
RokotOn
5 Posts
0
February 20th, 2019 06:00
Thanks for the answer, but then you really need to re-solder, you just need to choose the right processor for the FCBGA 1440 socket
RokotOn
5 Posts
0
February 20th, 2019 10:00
RokotOn
5 Posts
0
February 20th, 2019 11:00
Благодарю, пока что это теоретический вопрос для меня, закончу один проект, и возможно попробую на практике, все же риск велик, плату может погнуть температура или возникнет проблема с СМД компонентами. Пока что рисковать своей "рабочей лошадкой" не хочется.
JOcean
9 Legend
9 Legend
•
12.2K Posts
1
February 20th, 2019 11:00
I never considered that you would actually solder in a new processor. Obviously you have access to equipment and skills that the average user does not possess. My compliments to you!