Unsolved
This post is more than 5 years old
2 Posts
0
7938
M1000 Fan Control non standard enclosure
We are using a couple M1000 chassis in a non datacenter environment and are currently in the process of designing the enclosure. We need to be able to control the rate of the fans for a set of experiments to gauge flow rates and noise.
I have checked out the following documents without success
Chassis Management Controller Firmware Version 1.0 User Guide
Integrated Dell™ Remote Access Controller Firmware Version 1.11 User Guide
So there must be an un-published command to do this for testing etc?
I have checked out the following documents without success
Chassis Management Controller Firmware Version 1.0 User Guide
Integrated Dell™ Remote Access Controller Firmware Version 1.11 User Guide
So there must be an un-published command to do this for testing etc?
Scott Hanson
342 Posts
0
February 26th, 2009 11:00
No way to type "omchassis increase fan rpm x%"
paulbryant
2 Posts
0
March 2nd, 2009 04:00
How do you run the om commands remotely?
Thanks
Paul
Scott Hanson
342 Posts
0
March 2nd, 2009 15:00
You configure the ssh/telnet under the "Network/Security ... Services" tab of the CMC web interface.
When in the ssh/telnet session type "help" at the command line to list the commands, then "help " for more details.
All the docs are here --> http://support.dell.com/support/edocs/systems/pem600/en/index.htm
Hope that helps.