This post is more than 5 years old
542 Posts
0
787
Removing Enclosure0 on a BE bus
I am in the process of doing array side lun migrations to free up DAE's to move to another system. I am at the point where i need to remove the last DAE left on bus 3. it is Bus3_Encl0. All the others have been easy with no downtime but i just wanted to check if something would be different since this is the first enclosure on that bus.
I dont see anything in the CPG about it but i want to make sure it doesnt require a reboot or something. Hopefully the error it generates will be cleared with a SP management server restart like the others.
AranH1
2.2K Posts
0
September 2nd, 2010 08:00
Kenn,
You are correct, it will be just like removing all the other enclosures. A restart of the management server will clear the errors when the enclosure is removed and remove it from the array config. I have done it a few times and it was always the same as removing any other enclosure.
Aran
kenn2347
542 Posts
0
September 2nd, 2010 08:00
Thanks guys, just wanted a second opinion from the experts:)
nandas
1.5K Posts
0
September 2nd, 2010 08:00
If there is no other Enclosures left on the this Bus (Bus 3) - there should not be any issue. Rest Aran has already mentioned
Sandip