Unsolved
This post is more than 5 years old
29 Posts
0
274529
Is there a "rear fan" in Optiplex 745 SFF?
very simply, on the back of the MB on a GX745 there is what looks like a fan plug. I have this GX745 SFF motherboard in a GX745 DT (Desktop Form Factor) case, and aside from a BIOS errors below, it works perfectly.
The BIOS errors are;
1. Alert! Rear Fan Failure
2. Alert! Air temperature sensor not detected
I would suspect that the BIOS is looking for a fan with a thermistor (temp sensor) plugged in, just there is no place for a fan to go in the desktop form factor.
Is there a fan somewhere else on the SFF box aside from the front (obvious). (I'm not sure if there is a fan in the power supply, but I'd assume that there is) So, where would this extra fan be? Under the HDD assembly?
Anyone out there have a GX745 SFF that's actually looked inside the box?
The BIOS errors are;
1. Alert! Rear Fan Failure
2. Alert! Air temperature sensor not detected
I would suspect that the BIOS is looking for a fan with a thermistor (temp sensor) plugged in, just there is no place for a fan to go in the desktop form factor.
Is there a fan somewhere else on the SFF box aside from the front (obvious). (I'm not sure if there is a fan in the power supply, but I'd assume that there is) So, where would this extra fan be? Under the HDD assembly?
Anyone out there have a GX745 SFF that's actually looked inside the box?
patrickacox
270 Posts
0
June 18th, 2007 13:00
The temperature sensor is located near the front fan on each of the four chassis. The locations are as follows:
Sensor Location Signal Cable Mini-tower Integrated into the front I/O panel Shared with the I/O ribbon cable Desktop Integrated into the front I/O panel Shared with the I/O ribbon cable Small Form Factor Snapped into the front grill of the chassis in front of the fan 2-wire signal cable connects to the I/O board (shown below) Ultra Small Form Factor Integrated into the system board No cable necessaryThe image to the below shows the air temperature sensor on the SFF chassis. The 2-wire cable runs across the bottom of the chassis and connects to the I/O panel.
If the cable from the control panel to the system board is disconnected, the system displays an error on boot:
This message indicates the system did not detect the presence of the sensor or the cable is disconnected. Reseat the cable and reboot to see if the message still appears.
If the temperature of the sensor rises above 42° C (107.6° F), the system logs an error (Air Temperature Out of Range) in the Event Log accessible through System Setup. The air entering the customer’s system has exceeded the 42° C standard, and the system must now compensate with increased fan activity and noise.
NOTE:If the system reaches 42° C and logs an error in the Event Log, it still functions properly. The fans are just louder than normal.
Message Edited by patrickacox on 06-18-2007 09:50 AM
Message Edited by patrickacox on 06-18-2007 09:50 AM
gratzo
29 Posts
0
June 18th, 2007 15:00
One thing that seems odd - a temp sensor next to the air intake... You'd think that the temp sensor would be near the rear, and as it detected heat, would tell the BIOS to increase the fan speed.
Thanks again!
tahir kazmi
5 Posts
0
December 5th, 2011 05:00
i have optiplex745sff with intel core to duo processor e4400 2.0gege hz
at the start up error msg appear
1. Alert rare fan failure
press F1 to continue or F2 to run setup utality
plz any one help me to fix this problem
my mailing id is
<ADMIN NOTE:Email id removed per privacy policy>
speedstep
9 Legend
9 Legend
•
47K Posts
0
December 5th, 2011 06:00
The Rear Fan is under the hard drive in the sff.
1
release tabs (2)
2
hard drive
3
hard drive bracket
Replacing Rear Hard Drive Fan
DELL Hard Drive Blower Fan Plus Hard Drive Bracket and
Fan Caddy for OptiPlex 760 / 740 / 745 / 755 SFF & Dimension 5200c SFF
Dell Part Numbers: NY290, TJ160, NH645, NJ793
obear
7 Posts
0
December 14th, 2011 19:00
I too get this warning:
1. Alert rare fan failure
press F1 to continue or F2 to run setup utility
I moved the HD and turned the computer on, and the fan is running fine. The error seems to intermittent, but I want to figure out what is causing it. What other troubleshooting steps should i take?
lestat-7
1 Message
0
December 19th, 2011 09:00
i have the same problem with the rear fan
i have dell optiplex 745, i bought it today and it shows the msg
which states rear fan failure
i opened the case and found that there is no rear fan in my computer
i dont think i will be able find the fan here and buy it .
i just want the msg to be removed
BudgetBob
1 Message
0
December 25th, 2011 09:00
Did you ever resolve the rear fan failure? How?
obear
7 Posts
0
December 30th, 2011 14:00
I have not resolved it. Waiting for someone smarter than myself to come to the rescue
les-70
1 Message
0
January 31st, 2012 23:00
The error usually seems to occur when a dual core processor is added to a 745 SFF with no disk fan present. Dell (the bios) seem to think the system will then have disk which needs a fan. The opposite is true as the dual core gives off less heat than a pentium D. A fix which worked for me was to run the sense wire (yellow in my system and at the at the edge of the 5pin connector) to both front case fan connector and also to the matching pin on the fan connector for the disk fan. The rear fan then looks to be present for the bios. You need a spare dell 5 pin connector to do this, Easy to get by buying an old dell 5 pin fan on ebay. You should check the ebay picture to be sure it is 5 pin fan.
acemartini
1 Message
0
February 12th, 2012 05:00
This worked for me. I used an old CD Rom cable, trimmed off the lock so it would slip onto the motherboard header, pulled the yellow pin on the front fan connector and reinserted with a resistor lead. Lined up the pin/wire from the header and slipped over the resistor lead.
I did have an issue when all four wires were on the header, the power supply indicated a fault. I trimmed off the three extras and reconnected with just the one.
Thanks.
I now have a great mediacenter box (XBMC) that boots superfast and i dont have to have a keyboard to press F1!
.
dexie64
1 Message
0
July 1st, 2013 18:00
I know this is old post , but I hope that someone will put the pic of the wiring , since picture means thousand words and I am really struggling with this error.
I couldn't find anywhere else better explanation for this problem but still...
I mean, I have no fan on the back of HDD ;front is only one working good but I am not sure what yellow wire is in question.
TIA
D.
cdsmall12
1 Message
0
June 18th, 2014 13:00
HDD caddy has fan. not actual HDD
shesagordie
10 Elder
10 Elder
•
46K Posts
0
June 18th, 2014 14:00
This thread has been locked due to it's age, if you have a similar issue, please use the 'New post' feature at the top of this page and start a new thread.
Bev.