Unsolved
This post is more than 5 years old
3 Posts
0
29899
Equallogic Firmware upgrade
I have updated my PS 6000E 6.0.11 to 7.1.7. I reset my device gets following and after doing DeleteAllMyDataNow .
unable to initialize my device
CLI>
CLI> reset
% Error - Object does not exist
% Error - Object does not exist
Warning: This command resets an array to the factory
defaults (original condition). The result is the
elimination of all group and volume configuration
information and any volume data residing on the array.
It is strongly recommended that you not reset a running
array. Instead, use the delete member command which moves
data from this array to other arrays and automatically
resets this array.
This member Unknown
IP Addresses associated with this member:
Reset this array to factory defaults? [n/DeleteAllMyDataNow]
Mtexter
1 Rookie
1 Rookie
•
205 Posts
1
August 14th, 2015 08:00
You want to use the "restart" command, rather than "reset". Annoying isn't it?
Edit: Wait a second, you wanted to delete all your data? Now you have to re-run the "setup" command to re-initialize the system in order to use it again.