This post is more than 5 years old
2 Intern
•
360 Posts
0
7972
powerpath policy mode for CLARiiON & Symmetrix
Hi All,
What is the correct policy mode for CX & Symmetrix environment?
The host has CX LUN & Symmetrix LUN at the same time.
Thank you,
Dennis Dai
SamCl
54 Posts
0
November 17th, 2010 01:00
Assuming a fully Licensed PowerPath
For Symmetrix devices (VMax and DMX) the PowerPath Policy is 'so' (SymmOpt)
For Clariion devices the PowerPath Policy is 'co' (ClarOpt)
So for blanket setting of policies the following commands can be issued
powermt set policy=co class=clariion
powermt set policy=so class=symm
I hope this helps
Sam Claret EMC TSE3
Nollaig1
1 Rookie
1 Rookie
•
137 Posts
1
November 17th, 2010 01:00
Hello Dennis,
You can set the policy individually using the powermt set policy command, this can be set per powerpath device:
powermt set policy=li|lb|rr|re [class=symm|clariion|ess|hitachi|hpxp|invista|all] [dev=device|all]
powermt set policy=si [dev=device|all]
powermt set policy=so [dev=device|all]
powermt set policy=co [dev=device|all]
powermt set policy=ad
Description powermt set policy sets the load-balancing and failover policy for devices configured in PowerPath.
EMC usually recommend the policy SymmOPT (so) for Symmetrix devices and ClarOPT (co) for Clariion devices. But the policy choice is entirely up to the admin and dependent on the system requirements. The policys are listed in knowledgebase article emc248842.
The article is based on the EMC PowerPath Product Guide Version 5.1P/N 300-000-165, available on Powerlink. To access this guide, from the home page of Powerlink, select Support > Technical Documentation and Advisories > Software Documentation P - R > PowerPath Family > PowerPath > General Reference > PowerPath Product Guide
Hope this helps,
Nollaig