This post is more than 5 years old
1 Message
0
1911
VLAN Tagging and Isilon Access Zones
We have a new NL400 v7.1.1.1 cluster and want to do SMB tenant Access Zones with each Zone configured for a /27 network ( using 10GB interfaces). The System Zone is on a different /24 network( using 1GB interfaces ) and will be for mgmt and SyncIQ only. The default route has the /24 gateway and when I try to connect to one of the /27 zones ip's it timesout. I have tried adding static routes to each pool, but unless I have unique addresses and no overlap there are issues connecting. How do I get the Isilon to answer client request to a specfic access zone using that access zones gateway for its route. May have 20 access zones with 20 /27 networks each with there own gateways.
Peter_Sero
1.2K Posts
0
November 12th, 2014 07:00
OneFS 7.2 has introduced "source based routing" for these kind of scenarios.
Why not try that out on the virtual nodes/simulator.
(There was a note that the downloadable 7.2 simulator has some problem
installing or booting; don't know wether it has been fixed.
I started from a 7.1.1 simulator and did a regular code upgrade to 7.2.)
hth
-- Peter
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
November 12th, 2014 08:00
There is only one default gateway so you will need to set static routes or try SBR in 7.2 as Peter suggested. I am curious to see how SBR works on Isilon, it works pretty good on VNX (it's called IP Reflect)