This post is more than 5 years old
2 Posts
0
3259
How to backup a single saveset at a specific level
Hi,
we are running NetWorker 9.1.1.7. Last weekend one of the full backups failed. Yet we do not want to rerun the complete Job or even just the failed / incomplete savesets. But we are interested to backup some savesets at level full.
Any idea, how to do that?
crazyrov
4 Operator
4 Operator
•
1.3K Posts
0
May 10th, 2018 02:00
hschulte,
If you want the full backup of certain savesets only why dont you just add a client instance with the required savesets defined and add them to an adhoc workflow to take a full backup.
bingo.1
2.4K Posts
0
May 7th, 2018 09:00
Usually you just have to restart a workflow. However, the restart interval will most likely have timed out.
The easiest way to do that is to run a full client backup form the command line:
nsrworkflow -p -w -c -A "'backup' -l full"
hschulte
2 Posts
0
May 8th, 2018 01:00
Ok, but this will start the complete client rather than a single saveset.
ble1
2 Intern
2 Intern
•
14.3K Posts
0
May 8th, 2018 04:00
Depends what you exactly mean under save set here (drive, folder, whatever).... I would perhaps try slightly different approach here and use save command from client and exploit -t option (see manual for save command).
bingo.1
2.4K Posts
0
May 8th, 2018 04:00
Correct. You cannot define a specific save set from the command line.
However, if you restart a failed workflow, it will only backup the save set which have not finished successfully.
But to make this happen the restart interval must not have passed.