This post is more than 5 years old
20 Posts
1
3606
IOS upgrade
I need to upgrade the ios of the 6248 staked switches , Current ios PC6200v3.3.14.2 .
Please advice me how to upgrade stacked switches.
Thank you
This post is more than 5 years old
20 Posts
1
3606
I need to upgrade the ios of the 6248 staked switches , Current ios PC6200v3.3.14.2 .
Please advice me how to upgrade stacked switches.
Thank you
Top
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
1
July 25th, 2017 12:00
The firmware download includes a PDF that guides you step by step on how to apply the firmware.
http://dell.to/2uUklOX
Page 8 of the following white paper also has some information on the process.
http://dell.to/1Fd7Wps
And here is a video with the instructions.
http://bit.ly/LLNAZB
vt1012
212 Posts
1
July 30th, 2017 12:00
The configuration file only shows things that have changed from the default. The default settings do not show up in the configuration. For example, if you perform a "show running-config" you might see the same information as what you have listed above. If you want to see the entire switch or stack configuration including the default settings, try using the "show running-config all" command. The results will be very long, which is why they usually only show the changed settings. See the CLI reference guide for the 62xx here: http://downloads.dell.com/manuals/common/powerconnect-6224_reference%20guide_en-us.pdf . Page 1114 discusses using the "all" parameter. If you have in mind a particular command/setting and are not sure what the default is suppose to be you can also search the setting/command in this same guide and it will show the default setting under the "Default Configuration" section for that setting/command.
Hope this helps.
-B
liyabru
20 Posts
0
July 29th, 2017 07:00
After upgrade IOS ,
When i tried to backup my switches (stacked 6248) only can get this only .Please advice me how can get all details
Thanks
!Current Configuration:
!System Description "PowerConnect 6248, 3.3.14.2, VxWorks 6.5"
!System Software Version 3.3.14.2
!Cut-through mode is configured as disabled
!
configure
snmp-server location "EG COL"
hostname "goAMLPROSANSW"
stack
member 1 2
member 2 2
exit
switch 1 priority 1
ip address 10.10.10.20 255.255.255.0
ip default-gateway 10.10.10.1
username "admin" password 1682ee4c488eed4a8e8a4a5c1ce40098 level 15 encrypted
line console
password 488eed4a8e8a4a5c encrypted
exit
enable password 8eed4a8e8a4a5c1ce encrypted
exit
liyabru
20 Posts
0
July 31st, 2017 18:00
Thank you