Unsolved
This post is more than 5 years old
18 Posts
0
13827
Initial Configuration of 3548P
Hey All,
Having an issue tyring to setup a 3548P. I boot up the device and it passes the post... loads the sw image and gets to the setup wizard.
I press Y and it displays a message saying it timed out as i did not make an selection. After this it gets to the console> screen and I can't type anything in.
I'm using the secureCRT software to connect with VT100, 9600, 8N1 as noted in the configuration docs.
Any suggestions? I have done the same to other 3548P's and get the same result. I'm guessing its something to do with my setup?
Thanks
John
bh1633
909 Posts
0
May 20th, 2009 03:00
Flow control should be set to none.
Test your serial cable. Connect it to your PC and use a paper clip to connect pins 2 and 3. If the cable is good, everything you type on secureCRT should be echoed. If not, replace the cable.
NemoBCC
18 Posts
0
May 20th, 2009 15:00
Thanks for the tips.... I'll give it a go today.
NemoBCC
18 Posts
0
May 20th, 2009 20:00
was a flow control issue
thanks