Unsolved
3 Posts
0
1406
Network based on 2x F10 E1200i
Hello All, I've got a two F10 F10 E1200i, and I would like to set up a redundant network on them. I have a couple of questions. 1. How to make VLAN routing on those devices? On one F10 (named F01) I've created two VLAN interfaces:
- VLAN 2 (with 192.168.2.1 /24 IP address assigned),
- VLAN 3 (with 192.168.3.1 /24 IP address assigned).
I've connected one device to port with untagged VLAN 2 (with 192.168.2.10 /24 gateway: 192.168.2.1) and another device to port with untagged VLAN 3 (with 192.168.3.10 /24 gateway: 192.168.3.1).
Device with IP 192.168.2.10, can ping gateway 192.168.2.1, but cannot ping 192.168.3.1 and 192.168.3.10. And the same story with the second device in VLAN 3 - it can ping only the gateway 192.168.3.1 What do I need to do to make those devices visible for each other? And any other devices in the future also?
2. The second part is more complicated I'm guessing: I would like to make F10 redundant - so if one F10 will goes down, second will server the same gateways. Is it even possible with F10 E1200i devices? But here I don't know where to start even.
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
January 17th, 2019 09:00
Hi,
For the redundancy question the best method is to enable stacking on the switches so that they operate as a single switch. Page 4 https://www.force10networks.com/CSPortal20/KnowledgeBase/DOCUMENTATION/CLIConfig/FTOS/VS_CONFIG_6-May-2011.pdf
The VLANs should be able to communicate once you give them an IP address. Did you do a shutdown and no shutdown on the ports? Page 280 https://www.force10networks.com/CSPortal20/KnowledgeBase/DOCUMENTATION/CLIConfig/FTOS/Archive/E_Config_7.7.1.0_01-Jul-08.pdf
piotrberent
3 Posts
0
January 18th, 2019 03:00
Thanks for the reply!
How stack should be done physically? Just connect via Te ports? I was thinking about VRRP for this, but the stack is some kind of option.
For the VLANs - no they are not communicating for each other. I think I might use VRF?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
January 18th, 2019 08:00
Yes with the te ports. VRRP would work as well. I would try VRF and see if that does allow the VLANs to communicate.
piotrberent
3 Posts
0
January 18th, 2019 15:00
When I'm trying to add vrf forwarding to any VLAN interface, I'm getting the following error:
What is wrong with this VLAN interface configuration?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
January 21st, 2019 09:00
Are the individual ports in LACP as well as the port channel?