This post is more than 5 years old
7 Posts
0
7290
Problem With SNMP Scan
I am trying to run an SNMP scan from my asset management software and it isn't seeing my PowerConnect switches. Most of my switches are 3524's. The scan is using SNMP V1. Is there a setting I am missing to enable the switches to be seen? FYI, I have switch access locked down to HTTPS and SSH if that matters.
DELL-Victor
98 Posts
1
November 3rd, 2011 14:00
If you can, eliminate any security, ACLs, Firewall issues that may be between you and them, and make sure your default-gateway is set on each switch.
DELL-Victor
98 Posts
0
November 3rd, 2011 11:00
You will need to setup a community on the switches before discoverying them. The syntax is...
console(config)#snmp-server community
MSAdmin
7 Posts
0
November 3rd, 2011 12:00
I setup a community with "public" but it still doesn't see them on the scan. I have it set to:
String: public
Management Station: 0.0.0.0 (any)
Access Mode: Read Only
MSAdmin
7 Posts
0
November 3rd, 2011 14:00
Found the problem. I had my access profile set to https/ssh only. I had to add snmp to that list.