Unsolved
This post is more than 5 years old
79 Posts
0
969
Very Old 6248s with NO enable command
So I have inherited these Poweconnect 6248s and they have the original firmware 2.0.0.12, when I log in with the admin password, there is no enable command. all I have are a few show commands, has anyone ever seen this and what I can do to figure out why I cannot do anything on these switches
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
May 4th, 2017 17:00
Hi,
Will it let you show the running config? Can you get into the Web GUI? Are you able to flash to newer firmware from the boot menu?
BaghdadIT
79 Posts
0
May 5th, 2017 05:00
Josh
Negative to all three questions, I am trying to get into the webGUI with the same username and password I used to Console in, But it keeps telling me it is "invalid. I have never seen this before, The switch is working because I can get to the devices attached to it.
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
May 5th, 2017 09:00
Will it let you into the boot menu to clear everything?
BaghdadIT
79 Posts
0
May 10th, 2017 10:00
Josh Craig
If your still checking, No I cannot. I found a username and password that will let me into the GUI, But I can't do anything except change the image it boots to
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
May 10th, 2017 10:00
I have not been able to find any other method to make it work.