RAID PERC 4 Controller Replacement

You need to boot to CTRL-M, Configure, View/Add ... choose Disk View, then save on exit.

Under the Objects -->  Logical Drives, I see my 2 logical drive 0 and 1

The View/Add Page shows 2 columns -  1st column has the 4 hard drives 0, 1,2,3 and the proc.

Pyke

Thanks, Those options I listed are on the next page. 

View/Add Configuration, it shows 2 columns of drives.

Thanks

Thanks for the quick response,  I dont see an option for Disk View, my options are

Space - SEL

ENTER- End Array

F10 Configure

F2 Drive Info

F3- Logical Drives

F5 HSP

Thanks

Hi Flash,

I'm not getting a choice of anything on that next page, just the 2 columns of drives and that options menu i posted earlier, no NVRAM or Disk View on this page.

Pyke

From the Main menu, select Configure, and then View/Add from the next/sub menu:

The machine has 4 hard drives

0 - Online   - Maxtor Atlas
1- Online  - Maxtor Atlas

2- Online  -  Maxtor Atlas

3- Online      Maxtor Atlas

4-  Online -  but not responding

5- Fail

6 - Proc

7-   Blank

8- Online - Not Responding

9 -  Fail

10-15 Online - Not Responding

Both Logical Arrays are listed as Offline

Pyke

Then you have already either cleared or imported the configuration. What does the View/Add page look like (status, ID's, etc.)? If you go to Objects, Logical Drives, what is shown there?

The View/Add Page shows 2 columns -  1st column has the 4 hard drives 0, 1,2,3 and the proc.

Status of each ID? and the full ID for each?

What the View/Add option is doing is giving you the choice which configuration you want to use. If you choose NVRAM, it will show you the controller's configuration (since you replaced it, the controller's configuration is not what you want); if you choose Disk View, it will show you the configuration stored on the disks. When you exit View/Add after having chosen a configuration, it will ask you if you want to save that configuration. Choose Disk View, then save on exit.