Unsolved
This post is more than 5 years old
5 Posts
0
14474
1000E Issue
I have a Dell Passthru switch in slot A1. I show no power to it but I can flash the Info port (blue) on it from the LCD pannel. The CMC shows it installed but powered off. How can I turn this module on please?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
October 27th, 2015 17:00
Hi,
What version is the CMC firmware at? Is this a new module or one that was working previously?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
October 28th, 2015 12:00
Is it working now? Are there any cables connected?Try reseating the module to see if that powers it on, since it is a passthrough module it doesn't have a management interface.
Phil.Andersen
5 Posts
0
October 28th, 2015 12:00
Yes that has always worked. I can flash the blue info light on it hut can't figure out how to turn the power on to that module. The CMC is at 5.10.200
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
October 28th, 2015 13:00
Are both modules doing the same thing?
Phil.Andersen
5 Posts
0
October 28th, 2015 13:00
Resets no green power light, can still blink the blue. No cables plugged into it. I have the Dell pass thru modules in A1 and A2.
tester25
626 Posts
0
October 28th, 2015 13:00
It could be a fabric mismatch.
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
October 28th, 2015 14:00
Do any link lights come up if you connect cables? Can you try to swap the two modules to see if stays with the slot or the module?
Phil.Andersen
5 Posts
0
October 28th, 2015 14:00
No, the other module is powered up.
Phil.Andersen
5 Posts
0
October 28th, 2015 16:00
Looks like it is the module that maybe bad. I swapped A1 and A2 and it didn't power up when put in A2. In CMC it is still listed as POWER OFF