Start a Conversation

Unsolved

This post is more than 5 years old

5005

August 26th, 2008 13:00

Dell PowerEdge 1400sc

I have a 1400sc with 2 CPu's installed running server 2003 and server runs fine.  I need to take 1 CPU out because the Phone software does not recognize 2 cpu's.  When I take out the CPU in PROC2, the system will not boot and has an orange light on monitor.  If I leave PROC 2 in and take out PROC1 I at least get an error that main processor is missing from PROC1.

 

What am I missing, that will allow me to take out PROC 2 and run the server with 1 CPU.

2 Posts

August 26th, 2008 14:00

be sure to pull out the voltage regulator as well.

11 Posts

August 26th, 2008 15:00

were do I find the voltage regulator

2 Posts

August 26th, 2008 15:00

it sits behind the 2 processors and the fan. It is a small slot, release the two end clips and then you can pull it out. about 2" long.. has a lot of capasitors, resistors on it..

11 Posts

August 26th, 2008 15:00

I now know what you are talking about and will take it out and reply back, thanks.

11 Posts

August 26th, 2008 19:00

that worked thanks
No Events found!

Top