Unsolved
This post is more than 5 years old
3 Posts
0
162256
Powervault MD3000i IP address reset required
We have just purchased a Powervault MD3000i iSCSI unit and while setting it up I have locked myself out from being able to set the iSCSI TCPIP address (defaults were 192.168.128.101 and 192.168.128.102) I am unable to find out what the address's have changed to or to be able to reset them to the default values.
anybody any ideas???
mrokkam
154 Posts
0
May 13th, 2009 10:00
The 192.168.128.10x ports are the defaults for the MD3000i management ports. It might be easiest to contact dell tech support to help figure out the new IP addresses or to reset them.
<ADMIN NOTE: Broken link has been removed from this post by Dell>
This is a link to the array discovery and IP address setup just in case it might be of help.
-Mohan.
JOHNADCO
847 Posts
0
May 13th, 2009 13:00
These are your iSCSI ports? I'd hook up a lap top or something to the management ports then you can change them with the GUI easy enough.
Zbq85
9 Posts
0
April 15th, 2010 04:00
to accomplish this does the MD3000i have to be connected to your network? I have the flashing amber lights and cannot get access to the array.
mrokkam
154 Posts
0
May 3rd, 2010 15:00
You need to be connected to the same management network as the MD3000i to be able to manage it out-of-band. Otherwise, you will need in-band access (again using iSCSI and the network). So, in any case, you will need network access to manage the array. Support might be able to reset your management port IP addresses without it being connected to the network.
Mohan