Unsolved
29 Posts
0
664
What does this error indicate - Redundant path
I have an MD1200 connected via h800 - both with the latest firmware. I'm about to configure the array after I figure out what this error is indicating.
I have a single H800 connected to the MD1200 - oddly, I can't find a single diagram of a single dual port card connected to a SINGLE md1200 with 2 EMMs in it. I want a single large array - 1 partition - 1 volume with 12 drives connected.
This would be the config I have if that was a single card at the top with 2 cables coming out
Thanks
DELL-Sam L
Moderator
Moderator
•
7.1K Posts
0
August 28th, 2019 14:00
Hello boed,
Is your selector switch on the front of your MD1200 set to unified mode or split? Here is the link to the users guide and if you look on page 7 it shows where the select switch is located. https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_powervault/powervault-md1200_owners-manual_en-us.pdf
you will want to be in unified mode to have all 12drives seen by a single host.
Please let us know if you have any other questions.