Unsolved
4 Posts
0
2340
Precision T7400 POST Error
Hi to all! I have a Precision T7400 with a Intel Xeon 5150, but I have a POST Error: "System Does not support the installed processor", press F1 key to continue.... I updated the BIOS to the last version (A11) but the problem persist. Any idea?? Thks in advance!
Mary G
4 Operator
4 Operator
•
20.1K Posts
0
April 10th, 2019 08:00
Did you replace the processor or is it the one that came on your model? I found an old post that lists compatible processors and info about the heat sink--
https://www.dell.com/community/Desktops-General-Read-Only/Dell-T7400-cpu-upgrade-question/td-p/4550597
speedstep
9 Legend
9 Legend
•
47K Posts
0
April 15th, 2019 07:00
The S SPEC and STEPPING for DUAL CPU must match EXACTLY.
The Following processors are supported. Harpertown LGA771.
There are 2 heatsinks for the Precision T7400.
FN654 - Heatsink for 150W CPUs
FD841 - Heatsink for CPUs below 150W
https://ark.intel.com/content/www/us/en/ark/products/34446/intel-xeon-processor-x5450-12m-cache-3-00-ghz-1333-mhz-fsb.html
Supported Processors are
https://ark.intel.com/content/www/us/en/ark/products/codename/26555/harpertown.html
X5260
L5410
E5440
X5272
L5420
E5450 C0 SLBBE/SLASB
X5450
L5240
E5430
X5460
E5405
X5470
E5410
X5472
E5420
X5482
E5472
X5492
E5462
Gus77avo
4 Posts
0
April 16th, 2019 03:00
MaryG, thank you very much for your time!
The I bougth the T7400 just like is, I didn't do anything. I'm just trying to make it work better. I decide to buy a Xeon 5450.
Again, thank you very much!
Gus77avo
4 Posts
0
April 16th, 2019 04:00
Speedstep, thank you very much!
I'm going to buy a Xeon 5450, and let you know!
Thks!!