26 Posts
0
983
PERC 345 to X4 Backplane Cable
What is the part number for the cable that goes from the PERC 345 adapter card to the 4X 3.5 Hot Plug bays on a 15G R250?
BP_PWR_1 (Power connector on backplane) | HDD/ODD_PWR (PIB connector on the system board) |
CTRL_SRC_SA1 (Signal connector on the PERC) | BP_DST_SA1 (Signal connector on backplane) |
DELL-Shine K
4 Operator
4 Operator
•
3K Posts
0
March 16th, 2022 07:00
Signal cable : XMT6K - ASSY,CBL,SGNL,X4BP,MB,R250/350
Power Cable : 0F00J - ASSY,CBL,PWR,MB,BPODD,R250
DewayneD
26 Posts
0
March 16th, 2022 08:00
Also, are the G15 BP connections different than G14?
DewayneD
26 Posts
0
March 16th, 2022 08:00
I talked to Sales and they gave me another number 61F98. I suspect that is the kit number of the cables you gave me numbers for.
They said your part numbers and the one he gave me are all out of stock.
Is it possible to use another cable as a substitute? Or is there another outlet to look for cables? Or could the backplane be bypassed for direct drive connection while I wait for the cable to become available?
DewayneD
26 Posts
0
March 16th, 2022 12:00
To further clarify, I am looking at the Dell EMC PowerEdge R250 Installation and Service Manual page 45 Figure 37 Table 14. That is the cable I am looking for. I would remove the backplane from my servers and use this configuration. Then when cables are available in a couple months I could reinstall the Backplane.