Unsolved
This post is more than 5 years old
1 Rookie
•
48 Posts
0
2603
Unisphere prompting for an Access Control Pin after upgrade
I upgraded a Unisphere instance from 1.6 to 8.0.3 by forst upgrading SE and then upgrading Unisphere. It seems okay mostly but I noticed when I try to go into System->Settings-.Symmetrix Access Controls I get a pop-up asking for an Access Control PIN. I never set a PIN but I recall the upgrade saying that it would use the default and warning that if I set a PIN, i'd need it for future upgrades. Since it used the default I didn't expect to need to use it.
Has anyone seen this. Anyone know the default PIN?
I confirmed Access Control is not enabled on the array using symacl list.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
February 5th, 2016 07:00
Hi
I am also facing the same did you found any answer for this ..
Thanks
Debashis
Tom Butler
3 Posts
0
October 11th, 2018 12:00
Has any one answered this yet? I can't get into my VMAX to set up users.
finbarrcorksac
99 Posts
0
October 15th, 2018 04:00
you will need to engage with your local DellEmc field representative to get this PIN.