I have run into a problem installing Netware 6.5 on a Poweredge 700. The install continually restarts after it reaches the "load keyboard load debugger" lines on the loading screen. I have read the response to use the Dell Server Assistant (version 8.2) even though I installed on a Poweredge 2600 with the same disks in the same manner without problems. So once I used the Dell Assistant it says to leave the Netware Disk in while it reboots so it can continue the install. However once it reboots it goes back to the original install problem as if I had never used the Dell Assistant. I have tried removing the CD so it will not boot from it but this just ends at a DOS prompt with nowhere to go. I have also used a Dell Assistant with these same disks on another test server previously.