Unsolved
This post is more than 5 years old
1 Message
0
7352
February 4th, 2010 04:00
Not connected networkcards on M6220
Hey
We got a M1000e with two M610 servers and two M6220 switch. In windows I got 6 LAC but the 4 is not connected. I can't see what i have setup wrong.
The got two M6220 switch so i got at backup, therefor i got two lan cables to both and to cables to both from I MD3000i.
Hope that is the rigth info and hope you can help.
Randrup
We got a M1000e with two M610 servers and two M6220 switch. In windows I got 6 LAC but the 4 is not connected. I can't see what i have setup wrong.
The got two M6220 switch so i got at backup, therefor i got two lan cables to both and to cables to both from I MD3000i.
Hope that is the rigth info and hope you can help.
Randrup
No Events found!
Scott Hanson
342 Posts
0
February 4th, 2010 12:00
This doc should help with the flow of the connections --> http://www.dell.com/downloads/global/products/pedge/en/blade_io_solutions_guide_v1.2_jn.pdf
If you only have two switches you'll only be able to connect 2 physical ports from each of the blades. You have to have switches in all 6 module fabrics in the rear to physically connect all 6 ports.
Make sense ?