Unsolved
This post is more than 5 years old
12 Posts
0
454
August 24th, 2009 06:00
Post-upgrade error message.
Hi, All
After an upgrade from 3.1.1 to 4.0.1 there is the following message, appearing in ControlCenter and Putty (SSH) window:
"The cluster has completed the upgrade from 3.1.1-1207-703-13222 -1 to 4.0.1-2958-968-20593 40110 with service level U. There were failed post actions: All nodes online postcheck (4.0-119). Hardware failures postcheck (4.0-119). Incompatible configuration cleanup check action (4.0-119)."
(the text is placed in "Message of the day")
The upgrade looks like completed successefully.
The commands output of:
"Upgrade postcheck" and "Show upgrade actions" is ok.
When Running CDoctor/NTT script, it tells:
"state=[ok,running,upgrade_check_failed] type=[none,ok,upgrade_check_failed] stage=[done,ok,upgrade_check_failed]"
All nodes are online and has the same 4.0.1 code, no "failures".
What's wrong? How to check and cleanup the message?
Is it enough just to clean up the "Message of the day"?
After an upgrade from 3.1.1 to 4.0.1 there is the following message, appearing in ControlCenter and Putty (SSH) window:
"The cluster has completed the upgrade from 3.1.1-1207-703-13222 -1 to 4.0.1-2958-968-20593 40110 with service level U. There were failed post actions: All nodes online postcheck (4.0-119). Hardware failures postcheck (4.0-119). Incompatible configuration cleanup check action (4.0-119)."
(the text is placed in "Message of the day")
The upgrade looks like completed successefully.
The commands output of:
"Upgrade postcheck" and "Show upgrade actions" is ok.
When Running CDoctor/NTT script, it tells:
"state=[ok,running,upgrade_check_failed] type=[none,ok,upgrade_check_failed] stage=[done,ok,upgrade_check_failed]"
All nodes are online and has the same 4.0.1 code, no "failures".
What's wrong? How to check and cleanup the message?
Is it enough just to clean up the "Message of the day"?
holgerjakob_c0722c
2 Intern
•
337 Posts
0
August 25th, 2009 12:00
Informatio is not an ASN but as we manage more than 30 systems I get all kind of messages after upgrades like the one you mention.
So far nothing prevented such systems from operating normally.
I don't know why these messages appear as I would assume the upgrade procedures contain all necesary steps for a successful completion.
Best regards, Holger
Vit1
12 Posts
0
August 25th, 2009 22:00
I've performed all the steps according to the Procedure Generator. All the after-upgrade steps are completed successefully.
In CenteraViewer all nodes are online, no faults, firmware the same.
Vit.
holgerjakob_c0722c
2 Intern
•
337 Posts
0
August 26th, 2009 06:00
In this case I would just wait and see if no alert emails are generated. If not you should really be all set.
Holger
Vit1
12 Posts
0
August 26th, 2009 22:00
But the customer worries about error messages in ControlCenter.