This post is more than 5 years old
2 Posts
0
487
June 4th, 2008 13:00
Anyone using iSLB? Or multiple iscsi ports on the same switch?
I can't figure out how to do routing so that iSCSI clients on other subnets can access the iSCSI on the MDS.
It looks like the only routes you can configure are for INDIVIDUAL gigabit ethernet interfaces, and this does not help if your using more than one and/or VRRP,iSLB.
It looks like the only routes you can configure are for INDIVIDUAL gigabit ethernet interfaces, and this does not help if your using more than one and/or VRRP,iSLB.
No Events found!
ConnectrixHelpe
259 Posts
0
June 9th, 2008 12:00
Have you taken a look at the MDS 3.x Cookbook? It covers various scenarios using VRRP with iSLB. You should be able to configure the VRRP group to include all the Gigabit Ethernet interfaces that are part of the configuration and then enable the iSCSI initiator in dynamic iSLB mode so that the new iSCSI initiators are initialized as iSLB clients and not iSCSI clients. This should allow you to use routing to go to the single address across the different subnets.
Thank you.