1 Rookie
•
2 Posts
0
55
swap drives
Hi - I have two identical PS6210E EqualLogic units (drives/firmware same). They are both degraded, and I would like to decommission one of them in order to use the known working drives in the second unit (replacing its failed drives).
Is there a proper drive uninstall procedure that I must use in order for them to work in the second unit?
Thanks, in advance!
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
1
March 1st, 2024 00:53
Hello,
The donor array should be reset if possible. That will clear the RAIDset labels. If not when you put then in the other array it won't be available for use. Depending the FW, in the GUI you can highlight that foreign drive and clear it.
Optionally, at the CLI you can clear it with GrpName>member select MEMBERNAME disk select DISKNUMBER clear-label
The firmware is less critical than not mixing RPM speeds or SSD's with mechanical drives.
I am assuming these are no longer under warranty.
Regards,
Don
#iworkfordell
ArchieArchives
1 Rookie
1 Rookie
•
2 Posts
0
March 4th, 2024 18:50
@dwilliam62 Appreciate the response, Don. I'll give it a go...
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
0
March 5th, 2024 03:28
@ArchieArchives You are very welcome! Good luck!
Don
#iworkfordell