Hello,

I'm having difficulties with Blade storage PS m4110 setup. I've got two drives failed and would like to rebuild the RAID with 12 drives. Run storage full storage 'reset'. After storage initial setup in command line I'm trying to create RAID and receiving an error saying all disks should be added. There is a same message in command line as well. I'm pretty sure I was able to use partly populated PS6110 and other models.

gb3-grp07(member_lgb3-grp07)> raid-policy raid6
% Error - You cannot configure RAID on this array unless the system is fully
populated with drives. Add more drives to fully populate the system.

Has anybody faced that issue with PSm4110? I could not find any document with support disk layout for that model.

it is running V7.1.14

regards, Andrey