Powerpath 5.3 for Windows and wmi class win32_Diskdrive

Question

Hello Community, I'm working with Powerpath in a Windows environment. We are using MS SCCM 2007 to collect data from servers an distribute software like Powerpath for Updating Purposes. With earlier versions than 5.3, I could read the Powerpath Storage ID out of the wmi class win32_diskdrive where it was stored as PNP Device ID. Therefore I was able to built a SCCM Report to identify the EMC - Storage Subsystem like DMX3, or Clariion. With the Upgrade of Powerpath 5.3, the information does no longer exist, therefore I can't use the reports no longer. Is there a way, to get this information again from the wmi class ? Arniebaer

gadctm · Answer

Je serai absent(e) à partir du 19/07/2010 de retour le 12/08/2010.

Durant cette période:

le support GA est assuré par O. Chesnel et T. Frewer

la permanence GA/SI est assurée par S. Tantot (1132)

Cordialement,

Rémi

SamCl · Answer

Hello Just so you dont think we are ignoring your question I have posted the question with EMC engineering

Brion2 · Answer

Hello.  Has a case been opened with EMC Customer Support on this issue? Thanks, Brion

gadctm · Answer

Je serai absent(e) à partir du 19/07/2010 de retour le 12/08/2010.

Durant cette période:

le support GA est assuré par O. Chesnel et T. Frewer

la permanence GA/SI est assurée par S. Tantot (1132)

Cordialement,

Rémi

gadctm · Answer

Je serai absent(e) à partir du 19/07/2010 de retour le 12/08/2010.

Durant cette période:

le support GA est assuré par O. Chesnel et T. Frewer

la permanence GA/SI est assurée par S. Tantot (1132)

Cordialement,

Rémi

SamCl · Answer

Not as far as I am aware yet

Sam Claret

Technical Support Engineer III

Worldwide Technical Support – OSAPI Windows

Office Hours: Rotating shift, 7AM – 4PM GMT

Office #: +353 21 494 5981

Email: Sam.Claret@emc.com

PowerPath

Was this post helpful?