dmx to vnx using Open Replicator (Help)!

Question

I have a simple question. When executing open replicator do I place the target luns in the OR group and host group for the target host before the copy? I believe I just put them into the OR group and then moved them to the proper storage group after the host is shutdown and the last incremental copy executed.

Thanks!

Archuperi721 · Accepted Answer

In that case I suspect the session might created with –nocopy option. Can you tell me the command you used to create & activate the OR session? Regards, Periyakaruppan N (Peri),

admingirl · Answer

hot push! Thank you so much Dynamox

dynamox · Answer

push, pull ?

admingirl · Answer

The session started successfully, however, there is no movement. Stopped it with symforce and restarted and still the same thing.

admingirl · Answer

yes, and it's a hot push.

Archuperi721 · Answer

Is the session created with –copy method? Its required for the cold OR session. Regards, Periyakaruppan N (Peri),

Archuperi721 · Answer

If the session is copy on write / access and the session was created without –precopy option. Then there will not be a copy until its activated.

Once its activated the session will turned as either copy on write / access according to the configuration.

Regards,

Periyakaruppan N (Peri),

admingirl · Answer

i already activated the session and it is not copying.

admingirl · Answer

Thank you! I did not use the -nocopy option, I forgot -copy because I was validating my file. Too many late nights in a row! it's copying now.

Archuperi721 · Answer

That’s good… J Regards, Periyakaruppan N (Peri),

Symmetrix

dmx to vnx using Open Replicator (Help)!

Was this post helpful?