Page 12 NOTE: Although iDRAC is preinstalled in F200 and F600 nodes, caution is recommended when using iDRAC. Some iDRAC features and functionality are accessible with the iDRAC interface, but are not supported. OneFS only supports the following IPMI commands with the iDRAC interface:
Page 19 OneFS only supports the following IPMI commands with the iDRAC interface: ● Shutdown (power off) ● Reboot (power cycle) ● Startup (power on) ● Power Status (read-only)
ayas
Community Manager
•
7.3K メッセージ
0
2021年7月28日 00:00
Chieさん
残念ながらOneFSではiDRACに関してはIPMI機能のみをサポートしているので
iDRACのRJ45 ポートをクラスタ管理に使うことはできないです。
参考資料：
PowerScale F200 and F600 Node Installation Guide
Page 12
NOTE: Although iDRAC is preinstalled in F200 and F600 nodes, caution is recommended when using iDRAC. Some iDRAC features and functionality are accessible with the iDRAC interface, but are not supported. OneFS only supports the following IPMI commands with the iDRAC interface:
powerscale-f900-node-installation-guide
Page 19
OneFS only supports the following IPMI commands with the iDRAC interface:
● Shutdown (power off) ● Reboot (power cycle) ● Startup (power on) ● Power Status (read-only)
Chie
1 Rookie
•
38 メッセージ
0
2021年7月28日 06:00
ayasさん、ありがとうございます。やはりそうですよね・・・
Gen6の管理ポートは後からIPMI機能が付いた記憶がありますが、PowerScaleノードはIPMIのみなんですね。
ご確認ありがとうございました。