This post is more than 5 years old
18 Posts
0
3668
Clariion Message Invalid Multiple Cable
Hello,
I might be wrong in this forum, but I am running into issues with some Clariion CX300 (yes I know they are old and unsupported, however they work fine for my lab).
After relocation of my CX300's I run into the issue that one is calling a "Invalid Multiple Cable" status on one of the SPS. I exchanged the cables with a different one and rechecked the overall cabling whilst replacing. However even after using the cabling from a system which is fine, this one comes up with the same error. So I can rule out that it is the signaling cable.
Any idea / tip would be highly appreciated, as I would not like to replace the hole SPS, only because some 10 USD cable is corrupted...
Thanks
Yves
christopher_ime
2K Posts
0
February 5th, 2011 17:00
Firstly, welcome to the forums and to borrow a phrase from Chad Sakac, "Thank you for being an EMC customer".
See if the following knowledgebase article relates to your situation:
emc208744: "What does the SPS cabling state 'Invalid Multiple Cable' mean?"
Replug the cables going out from SPS to DAE0_0 to the right position.
Caution! This is an offline procedure because you have to replug both cables at the same time, which will cause the Boot DAE to power off.
comdivisionys
18 Posts
0
February 6th, 2011 03:00
Hi,
thanks, I removed all cables again, starting from scratch. Rebuilding the kit and guess what the error is gone. Looks like the CX and the SPS is much better in checking the cabling then you would expect... :-)
Anyway thanks for the quick support...