How to Power On Unit for Storage ML3

Published NOV 26, 2024

This video will demonstrate the how to Power On Unit for Storage ML3.

Power on the library by pressing Power on the Base Module just below the Operator Panel and hold for 5 seconds. The green
light illuminates. When the library is powered on, it inventories the tape cartridges in the magazines, checks the firmware version on all modules, configures the tape drives, confirms the presence of the existing modules, and searches for any new modules.

Suggested Videos

How To Change PIN for Storage ML3

How To Change PIN for Storage ML3

1:34

How To Install Expansion Module for Storage ML3

How To Install Expansion Module for Storage ML3

2:32

How To Replace Controller Card for Storage ML3

How To Replace Controller Card for Storage ML3

1:02

How To Install Base Module for Storage ML3

How To Install Base Module for Storage ML3

2:46

How To Access Recovery for Storage ML3

How To Access Recovery for Storage ML3

1:01

Related Articles