Be sure to read and follow the safety guidelines to protect your computer from potential damage and ensure your personal safety. For more information about safety guidelines, see the owner's manual at visit Dell.com/Support. Before you begin, turn off the computer and disconnect all the attached peripherals.
To remove the solid state drive 2280, loosen the four captive screws on the back of the base cover. Remove the six screws on the front and sides of the cover. Pry the cover off the system. Carefully remove it as there may be a cable attached. Remove the cable if there is one. Find and unplug the battery cable. Identify the solid state drive and remove the two screws. Unlatch and lift the drive out of the system.
To reinstall the solid state, drive 2280, place it back in the system. Re latch and install the two screws to secure the drive. Plug in the battery cable and reconnect any cable that was attached to the base cover. Place the base cover back on the system and secure it with the ten total screws. For more information about your Dell system, visit Dell.com/Support.
