This package provides the Dell ControlVault Windows Biometric Framework Integrated Driver and is supported on Precision and Latitude models that are running the following Windows Operating System: Windows 7.
Custom Instructions for DELL_CONTROLVAULT-WINDOWS-BI_A00_R308325.exe: NOTE: Installation order is very important – use the following procedure, including reboots or the software will not function properly: 1. Download the following software packages and install in the order listed below: a. Dell Data Protection | Access | Drivers Package. i. Double click package filename and select Custom installation Setup Type. ii. Uncheck the Dell ControlVault box. iii. Continue to follow the wizard installation instructions until completed. b. Dell ControlVault Windows Biometric Framework Driver package i. Double click package filename and follow the wizard installation instructions. ii. Go to the "C:\dell\drivers\R308325\" USH folder and double click on CVHCI.msi and follow the wizard installation instructions until completed. iii. Reboot. c. Dell ControlVault Firmware i. Double click package filename and follow the wizard installation instructions. ii. Go to "C:\dell\drivers\R308325\" firmware folder and double click on ushupgrade.exe and follow the wizard installation instructions. iii. In the pop up dialog window press the Start button. iv. When installation is completed press the Restart button. The system will reboot. 2. Enable ControlVault Windows Biometric Framework feature (Start->All Programs->Broadcom->USH Tools and click on ControlVault WBF a. In pop up dialog window select Enable and the press the Set button. b. Press the Exit button. c. Allow time for any windows updates to complete. Errata Data: Windows Update may sometimes conflict with the installation of the Dell ControlVault Windows Biometric Framework driver installation and not allow proper installation. To identify if this occurs, go to Device Manager (Start->My Computer->Properties->Device Manager) and click on “Biometric Devices” and notice if there is a yellow exclamation mark (yellow bang) on the “ControlVault w/Fingerprint swipe sensor”. If this is so, right click on “ControlVault w/Fingerprint swipe sensor” and select Update Driver and choose “Browse my computer for driver software. Wait until Driver has been detected and installed (~30 secs).