Custom Instructions for Broadcom_QDMA-Broadcom-Chips_A00_R174387.exe:
Install Instructions
====================
This driver package contains the Windows x86 device driver
for the HT1000 controller.
To build the installation media these files should be
copied to a blank floppy diskette.
For systems which use onboard SATA Port for connecting SATA HDD,
the driver can be installed only during OS Installation.
For systems which use SATA ODD/SATA Tape alone on onboard SATA Ports,
the driver can be installed either during OS Installation or after OS Installation.
Installing HT1000 Driver during Operating System Installation
-------------------------------------------------------------
1. Power on the system and boot to the Microsoft Windows Server CD.
2. When the message "Press F6 if you need to install a third party SCSI
and RAID driver" appears, press the "F6" key immediately. Within a few
minutes, a screen will appear asking for the driver to support the
additional controllers in the system.
3. Press the "S" key.
The system prompts for the driver diskette to be inserted.
4. Insert the driver diskette in the floppy drive and press the "Enter" key.
The HT1000 chipset driver will appear.
5. Press the "Enter" again key again to continue the
installation process.
Installing HT1000 Driver after OS Installation
----------------------------------------------
Perform the following steps to configure the driver when you add a new
controller to a system that already has Windows installed.
1. Power down the system.
2. Install the new SATA ODD/SATA Tape in the system.
Refer to Hardware Installation for detailed instructions on
installing and cabling the SATA ODD/SATA Tape in the system.
3. Power on the system.
Enable the specific port in BIOS
The Windows operating system should detect the new
controller and display a message to inform the user.
4. The Found New Hardware Wizard screen will pop up and display
the detected hardware device.
5. Click on Next.
6. On the Locate Device Driver screen, select Search for a suitable
driver for my device and click on Next.
7. Insert the appropriate driver diskette or USB key and select that
device on the Locate Driver Files screen.
8. Click on Next.
9. The wizard detects and installs the appropriate device drivers for
the new controller.
10.Click on Finish to complete the installation.
11.Reboot the server.