Connectrix B-Series: Verify Connectivity Between Switch to External Device Using Telnet

Summary: If ping is disabled, the user can verify the switch connectivity to an external server using telnet.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

  1. Log in to the switch using root
  2. Run telnet command:
Syntax: 
"telnet <IP ADDRESS OF SERVER > <PORT>"

Example of performing telnet to verify if a connection to a server using port 443 is available: 
  • Successfully connected:
root> telnet 10.1x.1x.1xx 443
Trying 10.1x.1x.1xx...
Connected to 10.1x.1x.1xx.
Escape character is '^]'.
^]
telnet> close
Connection closed.
  • Connection Refused: 
root>telnet 1.x.x.0.1 443
Trying 1x.0.0.1...

telnet: Unable to connect to remote host: Connection refused

Additional Information

NOTE: The telnet command is not available on the older switch models and FOS.


NOTE: For switch above 9.1.x, the user requires serviceshell access from Broadcom to run these commands as root account is disabled.

Affected Products

Brocade, Connectrix B-Series Hardware, Connectrix B-Series Software
Article Properties
Article Number: 000203714
Article Type: How To
Last Modified: 11 June 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.