Data Domain: Determining the filesystem cleaning schedule and setting the schedule

Summary: Determining the filesystem cleaning schedule and setting the schedule

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

PURPOSE:     

Determining the filesystem cleaning schedule and setting the schedule.

APPLIES TO:      
  • All Data Domain systems

PROBLEM:      

Cleaning is not running when expected because the schedule is set wrong.


SOLUTION:      

  1. Connect to the DDOS command line through SSH or the serial console.

  2. Verify the status of cleaning: # filesys clean status

  3. Verify the current cleaning schedule: # filesys clean show schedule

  4. Set the new schedule for cleaning as desired. For example, to run cleaning once per week on Tuesday at 0600, use this syntax: # filesys clean set schedule tue "06:00"

Further syntax instructions are in the command reference guide: PowerProtect and Data Domain core documents

  1. Verify you have set the schedule as desired:  # filesys clean show schedule

  2. Start a cleaning if desired: # filesys clean start

 

Additional Information

Please refer this published video:

Affected Products

Data Domain
Article Properties
Article Number: 000022727
Article Type: How To
Last Modified: 18 Sept 2025
Version:  5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.