Connectrix : Le transfert Syslog est activé, mais n’est pas envoyé au serveur Splunk

Summary: Les paramètres auditCfg (--class, --enabled --show) sont activés, mais n’envoient pas d’informations syslog au serveur Splunk.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

Activation du transfert syslog sur le commutateur Brocade pour envoi au serveur Splunk, mais les informations syslog ne sont pas envoyées.

 

Cause

** SOMEONE SET THE RASLOG QUIET TIME FOR AUDITCFG BACK IN OCT **

Thu Oct 25 06:43:54 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -enable 3
Thu Oct 25 06:44:02 2018         admin, , xxx.xx.xx.x, rasadmin --quiet -show

** HERE IS THE CONFIG FILE FROM non-working **

auditlog.quiettime.dow:FOREVER
auditlog.quiettime.enable:1
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,4,10
audit.cfg.severity:4

audit.cfg.state:1

*** HERE IS THE CONFIGSHOW FROM working ***

auditlog.quiettime.dow:NA
auditlog.quiettime.enable:0
auditlog.quiettime.endtime:NA
auditlog.quiettime.starttime:NA
snmp.auditInterval:60
audit.cfg.class:2,10
audit.cfg.severity:3
audit.cfg.state:1

 

Resolution

Le client peut utiliser la commande suivante pour autoriser le transfert syslog sur Splunk.

rasadmin --quiet -disable 3

 

Affected Products

Connectrix DS-6610B

Products

Connectrix DS-6610B
Article Properties
Article Number: 000057296
Article Type: Solution
Last Modified: 21 Oct 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.