VxBlock: How to run a Health Check on VMAX3 or PowerMax from Unisphere
Summary: How to run a Health Check on VMAX3/PowerMax from Unisphere for VMAX / PowerMax.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Instructions
How to run a Health Check on VMAX/PMAX from Unisphere
Once logged into EMC Unisphere for VMAX 8.x GUI, follow the steps below:
-
Click on the VMAX3 Serial Number where a Health Check should be run.
-
Click on System (blue tab at the top).
-
Under the 'Health & Maintenance' box at bottom left, click on Health Check.
-
Click on the Run button on bottom left to start the script.
The Health Check will take approximately 5 minutes to complete, after which presenting a list of tests and results.
The following screenshots are for Unisphere for PowerMax 9.x.
Unisphere for PowerMax > Serial No > Dashboard > System Health > Action > Run Health Check.
Affected Products
VxBlock and Vblock SystemsArticle Properties
Article Number: 000197729
Article Type: How To
Last Modified: 19 Nov 2025
Version: 5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.