Connectrix: The fclag command does not display any output

Summary: This issue is seen on the Switch Command Line Interface (CLI) when a new fclag member is successfully created but does not list any data.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

The following error appears:

Switch :  fclag --show

^C
Switch :> 33271
Switch :> fclag --perf

^C^C
Switch :>

Cause

This issue is due to a background stuck process and switch Control Processors (CPs) not being in synchronization.

Resolution

Run the hafailover command to synchronize the background process.
 

Additional Information

When the FC-LAG feature is enabled, a link aggregation protocol is run between the remote Fabric Interconnect (FI) and the switch. All the underlying physical links are configured into a single aggregated link.

  • A maximum of 96 FC-LAGs are allowed to be configured in a switch.
  • A maximum of 96 FC-LAGs are allowed to be configured in each switch partition.
  • The maximum number of physical links under each FC-LAG is 16.
  • All physical ports within an FC-LAG must have the same speed, and the FC-LAG must be formed within the same switch.

Affected Products

Connectrix B-Series Fabric OS 9.X
Article Properties
Article Number: 000207071
Article Type: Solution
Last Modified: 27 May 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.