Connectrix Cisco MDS：當交換器直接連接到 CSSM 時，無法安裝信任代碼

Summary: 拓樸 2：直接連接到 CSSM。 在這種類型的連接中，通信是直接建立的，並且從交換機到CSSM的可信連接。 直接連接需要與 CSSM 的網路可達性。 交換器的傳輸類型設定為「Call Home」。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

安裝的信任代碼顯示「<無>」，且無法在「顯示授權狀態」下更新其狀態，而不會在「顯示記錄記錄」中發生任何錯誤。 
`show license status`
Utility: 
    Status: DISABLED

Smart Licensing using Policy:
    Status: ENABLED

Data Privacy: 
    Sending Hostname: yes 
    Callhome Hostname Privacy: DISABLED 
        Smart Licensing Hostname Privacy: DISABLED 
    Version Privacy: DISABLED 

Transport: 
    Type: Callhome
.
.
.
Trust Code installed: <none>  >> The trust code status shows none.

Cause

無法連接 CSSM，且設定的傳輸類型為 CallHome。
使用以下命令檢查 URL 是否正確配置，如下所示： https://tools.cisco.com/its/service/oddce/services/DDCEService。

 show license status

 

Switch : san002
callhome
  email-contact <Company email ID>
  streetaddress <Site address>
  distribute
  destination-profile full_text
  destination-profile full_text format XML
  destination-profile full_text message-size 100000
  destination-profile test
  destination-profile test format XML
  destination-profile test message-level 5
  destination-profile xml transport-method http
  destination-profile xml message-level 2
  .
  .
  .
  destination-profile xml http https://tools.cisco.com/its/service/oddce/services/DDCEService > this URL configuraion should be present in callhome config.
  destination-profile test alert-group system
  transport email from <Company email ID>
  transport email reply-to <Company email ID>

Resolution

配置 URL 並檢查使用 URL 更新的呼叫總部配置。 
switch# configure terminal
switch(config)# ip domain-lookup
switch(config)# ip domain-name cisco.com
switch(config)# ip name-server 171.70.xx.xx
switch(config)# callhome
switch(config-callhome)# dest xml trans http
switch(config-callhome)# dest xml email sl-sch-test@cisco.com
switch(config-callhome)# dest xml http https://tools.cisco.com/its/service/oddce/services/DDCEService
switch(config-callhome)# enable
switch(config-callhome)# commit*
switch(config-callhome)# exit
switch(config)# feature license smart
請確定已啟用 CallHome 分配器。否則，提交將失敗。
設定 URL 後，請使用下列內容安裝信任代碼：
在交換器上執行命令： 
switch# license smart trust idtoken id_token_value all
ID 權杖應從 CSSM 入口網站的「一般清查>」標籤底下複製。 
san002# show license status
Utility:
    Status: DISABLED
Smart Licensing using Policy:
    Status: ENABLED
Data Privacy:
    Sending Hostname: yes
    Callhome Hostname Privacy: DISABLED
        Smart Licensing Hostname Privacy: DISABLED
    Version Privacy: DISABLED
Transport:
    Type: Callhome
.
.
.
Trust Code installed: Sep  2 13:10:07 2024  UTC
    Active: PID: DS-C9706, SN: FXS24XXXXXX
        Sep  2 13:10:07 2024  UTC
    Standby: PID: DS-C9706, SN: FXS24XXXXXX
        Sep  2 13:10:07 2024  UTC

Additional Information

參考連結： https://www.cisco.com/c/en/us/td/docs/dcn/mds9000/sw/9x/configuration/licensing/cisco-mds-9000-nx-os-licensing-guide-9x/m-mds900-ssl.html#Cisco_Concept.dita_4879e553-bac5-4c52-800b-d84219951758

Products

Connectrix MDS-Series Firmware
Article Properties
Article Number: 000228278
Article Type: Solution
Last Modified: 16 Sept 2024
Version:  1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.