Dell Networking SONiC: 링크 계층 검색 프로토콜

Summary: 이 문서에서는 Dell Networking SONiC의 LLDP(Link Layer Discovery Protocol) 및 구성에 대해 설명합니다. 이 문서에서는 Dell SONiC 4.1을 실행하는 스위치를 사용합니다.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Instructions

 
필수 구성 요소
표준 인터페이스 명명을 사용하여 개념을 시연하고 있습니다. Dell Networking S-Series에 202172 문서를 참조하십시오. 기본 인터페이스 구성 - 인터페이스 명명에 대한 자세한 내용을 보려면 SONiC 4.0


인덱스

소개
구성 구문 
    LLDP를 활성화하고 비활성화합니다. 
    LLDP 전송
구성LLDP 수신
구성LLDP 전송 및 수신을 활성화합니다.       
    LLDP에서 관리 주소와 시스템 이름 및 설명을 보낼 수 있습니다.
확인
 

소개

LLDP(Link Layer Discovery Protocol)를 사용하면 스위치가 주요 기능과 물리적 설명을 알릴 수 있습니다. LLDP는 IEEE 802.1AB에 정의되어 있습니다. 이 정보는 시스템 토폴로지 식별 및 LAN에서 잘못된 구성을 감지하는 데 사용할 수 있습니다. 

  • LLDP는 단방향 프로토콜입니다. 요청 또는 응답 시퀀스가 없습니다. 전송 기능을 구현하는 스테이션은 정보를 알리고 수신 기능을 구현하는 스테이션은 정보를 수신하고 처리합니다.
  • 전송 및 수신 기능은 각 스위치 포트에서 별도로 활성화 또는 비활성화할 수 있습니다. 
  • LLDP는 공급업체에 중립적인 검색 프로토콜입니다. 
  • 스위치는 LLDP PDU(Protocol Data Unit)를 수신하고 주기적으로 전송합니다. 기본 전송 간격은 30초입니다.
  • 인접에서 수신된 LLDP PDU 정보는 특정 시간(TTL)이라고 하는 시간이 지나면 만료됩니다. 기본 TTL 값은 120초입니다.
  • 스패닝 트리 차단 포트는 LLDP PDU를 허용합니다.

구성 구문

참고: LLDP 구성이 변경된 후 LLDP 테이블이 120초(TTL)로 업데이트됩니다.

LLDP를 활성화하고 비활성화합니다.  

Enable LLDP Globally
admin@DELLSONiC:~$ sonic-cli
DELLSONiC# configure
DELLSONiC(config)# lldp enable
DELLSONiC(config)# end

Disable LLDP Globally 
DELLSONiC# configure  
DELLSONiC(config)# no lldp enable 
DELLSONiC(config)# end

Enable LLDP on a single interface
DELLSONiC# configure 
DELLSONiC(config)# interface Eth slot/port[/subport]
DELLSONiC(config-if-EthX/X)# lldp enable
DELLSONiC(config-if-EthX/X)# end

Disable LLDP on a single interface 
DELLSONiC# configure 
DELLSONiC(config)# interface Eth slot/port[/subport]
DELLSONiC(config-if-EthX/X)# no lldp enable 
DELLSONiC(config-if-EthX/X)# end
 

LLDP 전송 구성

이러한 명령을 수행하면 LLDP 수신이 비활성화됩니다.
Enable LLDP Transmit Globally
admin@DELLSONiC:~$ sonic-cli
DELLSONiC# configure
DELLSONiC(config)# lldp transmit
DELLSONiC(config)# end

Enable LLDP Transmit on a single interface
DELLSONiC# configure 
DELLSONiC(config)# interface Eth slot/port[/subport] 
DELLSONiC(config-if-EthX/X)# lldp transmit
DELLSONiC(config-if-EthX/X)# end


Enable LLDP Transmit and Receive (Click here) 
 

LLDP 수신 구성

이러한 명령을 수행하면 LLDP 전송이 비활성화됩니다.  
Enable LLDP Receive Globally 
admin@DELLSONiC:~$ sonic-cli 
DELLSONiC# configure 
DELLSONiC(config)# lldp receive
DELLSONiC(config)# end 

Enable LLDP Receive on a single interface
DELLSONiC# configure  
DELLSONiC(config)# interface Eth slot/port[/subport]
DELLSONiC(config-if-EthX/X)# lldp receive
DELLSONiC(config-if-EthX/X)# end

Enable LLDP Transmit and Receive (Click here)  
 

LLDP 전송 및 수신을 활성화합니다.

기본적으로 LLDP 전송 및 수신은 기본적으로 활성화되어 있습니다.
LLDP 전송이 구성된 경우 LLDP 수신이 비활성화됩니다.
LLDP가 구성된 경우 LLDP 전송이 비활성화됩니다.
둘 다 활성화하려면 LLDP 수신 및 LLDP 전송을 제거하십시오.
Enable LLDP Transmit and Receive Globally 
admin@DELLSONiC:~$ sonic-cli 
DELLSONiC# configure 
DELLSONiC(config)# no lldp receive
DELLSONiC(config)# no lldp transmit
DELLSONiC(config)# end 

Enable LLDP Transmit and Receive on a single interface
DELLSONiC# configure  
DELLSONiC(config)# interface Eth slot/port[/subport]
DELLSONiC(config-if-EthX/X)# no lldp receive
DELLSONiC(config-if-EthX/X)# no lldp transmit
DELLSONiC(config-if-EthX/X)# end
 

LLDP에서 관리 주소와 시스템 이름 및 설명을 보낼 수 있습니다.

기본적으로 LLDP는 시스템 이름 및 시스템 설명을 알 수 있습니다.
LLDP에서 관리 주소를 광고하려면 lldp tlv-select management-address를 수동으로 구성해야 합니다.  
Use bellow configuration to enable system-name, system-description and management-address
DELLSONiC# configure
DELLSONiC(config)# lldp system-name 
DELLSONiC(config)# lldp system-description 
DELLSONiC(config)# lldp tlv-select management-address
DELLSONiC(config)#end

Disable system-name, system-description and management-address
DELLSONiC# configure
DELLSONiC(config)# no lldp system-name
DELLSONiC(config)# no lldp system-description
DELLSONiC(config)# no lldp tlv-select management-address
DELLSONiC(config)#end

You have an option to manually specify the IPv4/IPv6 address of management address manually
DELLSONiC# configure
DELLSONiC(config)# interface Eth slot/port[/subport]
DELLSONiC(config-if-Eth1/1)# lldp tlv-set management-address  
DELLSONiC(config-if-Eth1/1)# end *Applying this command will make Switch to send LLDP in the specific interface with configured IPV4/IPV6 address, rather than management port IP address. To disable use DELLSONiC# configure DELLSONiC(config)# interface Eth slot/port[/subport] DELLSONiC(config-if-Eth1/1)# lldp tlv-set management-address DELLSONiC(config-if-Eth1/1)# end
 

확인

구성 구문
DELLSONiC# show lldp table 모든 LLDP 인접 항목의 여름을 표시합니다.
DELLSONiC# show lldp neighbor 모든 LLDP 인접 항목의 세부 정보를 표시합니다.
DELLSONiC# show lldp neighbor Eth slot/port[/subport] 특정 인터페이스에서 LLDP 인접의 세부 정보를 표시합니다.
DELLSONiC# show lldp statistics 모든 LLDP 인접 항목의 LLDP 통계를 표시합니다.
DELLSONiC# show lldp statistics Eth slot/port[/subport] 특정 인터페이스에서 LLDP 통계를 표시합니다.

샘플 출력
DELLSONiC# show lldp table
------------------------------------------------------------------------------------------------------
LocalPort           RemoteDevice        RemotePortID        Capability          RemotePortDescr
-------------------------------------------------------------------------------------------------------
Eth1/1              DELL-EDGE-sonic               Eth1/1              R                   Ethernet0
DELLSONiC# show lldp neighbor Eth 1/1
-----------------------------------------------------------
LLDP Neighbors
-----------------------------------------------------------
Interface:   Eth1/1,via: LLDP
  Chassis:
    ChassisID:    XXXXXXXXXXXXXXXXXXXXXXXX
    SysName:      DELL-EDGE-sonic
    SysDescr:     DELL-CORE
    TTL:          120
    MgmtIP:       30.0.0.1
    Capability:   ROUTER, ON
  Port
    PortID:       Eth1/1
    PortDescr:    Ethernet0
  LLDP-MED
    Device Type:  Network Connectivity Device
    Capability:   Capabilities, yes
    Capability:   Ext_mdi_power_pd, yes
    Capability:   Inventory, yes
    Capability:   Network_policy, yes
    Inventory
      Hardware Rev:  XXXXXXXXXXXXXXXXXXXXXXXX
      Software Rev:  XXXXXXXXXXXXXXXXXXXXXXXX
      Firmware Rev:  XXXXXXXXXXXXXXXXXXXXXXXX
      Serial Number:
DELLSONiC# show lldp statistics Eth 1/1
LLDP Statistics
---------------------------------
Interface: Eth1/1
    Transmitted      : 60
    Received         : 45
    Discarded        : 0
    Unrecognized TLV : 0
    Ageout           : 1
---------------------------------

Affected Products

Enterprise SONiC Distribution, PowerSwitch E3200-ON Series, Dell EMC Networking N3200-ON, PowerSwitch S5212F-ON, PowerSwitch S5224F-ON, PowerSwitch S5232F-ON, PowerSwitch S5248F-ON, PowerSwitch S5296F-ON, PowerSwitch Z9100-ON, PowerSwitch Z9264F-ON , PowerSwitch Z9332F-ON, PowerSwitch Z9432F-ON ...
Article Properties
Article Number: 000218154
Article Type: How To
Last Modified: 16 Oct 2023
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.