Connectrix MDS upgrade returns message "Pre-upgrade check failed "Return code -1."
요약: When performing Connectrix MDS upgrade, the "install all" command returns the message "Pre-upgrade check failed. "Return code -1."
이 문서는 다음에 적용됩니다.
이 문서는 다음에 적용되지 않습니다.
이 문서는 특정 제품과 관련이 없습니다.
모든 제품 버전이 이 문서에 나와 있는 것은 아닙니다.
증상
On attempt to run "install all" command, the switch returns the message "Pre-upgrade check failed. "Return code -1."
No indications of what is wrong, md5sum of the firmware files are good. Enough space on the bootflash: and also on the standby supervisor but still the "install all" command fails with "Return code -1."
No indications of what is wrong, md5sum of the firmware files are good. Enough space on the bootflash: and also on the standby supervisor but still the "install all" command fails with "Return code -1."
원인
The command
runs fine.
The command
(This is the same message as the "install all" command.)
"show incompatibility-all system bootflash:m9700-sf2ek9-xxxx.bin"
runs fine.
The command
"show install all impact kickstart bootflash:m9700-sf2ek9-kickstart-mz.xxxx.bin system bootflash:m9700-sf2ek9-mz.xxxx.bin" fails with "Return code -1."
(This is the same message as the "install all" command.)
해결
Workaround:
- Perform a "system switchover" command to failover to the second supervisor. Wait until the command completes. Use the command "show system redundancy status" to confirm the action completes.
- Perform a second "system switchover" command to go back to the previously active supervisor where the upgrade code currently resides.
- Rerun the "install all" command and upgrade should complete.
해당 제품
Connectrix MDS-9710-V2, Connectrix MDS-Series Firmware 8.X제품
Connectrix MDS-9506, Connectrix MDS-9509, Connectrix MDS-9513, Connectrix MDS-9706, Connectrix MDS-9706-V2, Connectrix MDS-9710, Connectrix MDS-9718, Connectrix MDS-9718-V3문서 속성
문서 번호: 000197811
문서 유형: Solution
마지막 수정 시간: 10 9월 2025
버전: 6
다른 Dell 사용자에게 질문에 대한 답변 찾기
지원 서비스
디바이스에 지원 서비스가 적용되는지 확인하십시오.