NetWorker: vProxy Appliance Does Not Apply Network Parameters on Deployment

Sammanfattning: vProxy appliance does not apply or retain network parameters.

Den här artikeln gäller för Den här artikeln gäller inte för Den här artikeln är inte kopplad till någon specifik produkt. Alla produktversioner identifieras inte i den här artikeln.
Kolla in andra resurser

Symptom

The NetWorker VMware Protection (NVP) vProxy appliance deploys successfully but did not apply network parameters set during the deployment.

Orsak

There is a duplicate IP address. Another device has been assigned the same address as the vProxy appliance.

Upplösning

  1. On the vProxy appliance, check the status of the wickedd service with the below command. Wickedd is the network management service used on the vProxy appliance. 
NOTE: If the vProxy is not accessible over SSH, use VMware web client to console connect to the vProxy. 
systemctl status wickedd
Results of wickedd Command showing duplicate IP 
Figure 1: Message Results of wickedd Command
 
To see the full messages, use the following wickedd command: 
systemctl -l status wickedd
(lower case L)

Example:
Message Results of Extended wickedd Command
Figure 2: Message Results of Extended wickedd Command
 
Write down the MAC address and work with network administrator to find the duplicate IP and resolve or assign a different IP address to the vProxy.
  1. Resolve duplicate IP address issue in the networking environment.
  2. Reconfigure the vProxy's network parameters using:
/opt/emc/vproxy/bin/network_config.sh <interface> <FQDN> <IP Address> <Netmask> <Gateway> <DNS List (comma separated)>

Berörda produkter

NetWorker

Produkter

NetWorker Family, NetWorker Series
Artikelegenskaper
Artikelnummer: 000212275
Artikeltyp: Solution
Senast ändrad: 27 feb. 2026
Version:  3
Få svar på dina frågor från andra Dell-användare
Supporttjänster
Kontrollera om din enhet omfattas av supporttjänster.