ECS: CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS
摘要: CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS.
本文适用于
本文不适用于
本文并非针对某种特定的产品。
本文并非包含所有产品版本。
说明
CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS. Centera supports this type of behavior. This is known limitation in ECS-CAS implementation, and it comes from the architectural differences between Centera and ECS.
Description:
There are two CAS buckets under one namespace TEST.
dc_bucket
dr_bucket
There are two object users to have these buckets as default CAS bucket.
dc_profile has dc_bucket as default CAS bucket
dr_profile has dr_bucket as default CAS bucket
The below ACLs were configured.
dc_bucket: dc_profile -> Full, dr_profile -> Read and Read ACL
dr_bucket: dc_profile -> Read and Read ACL, dr_profile -> Full
After writing one object to ECS using dc_profile PEA, this clip can be accessed using dc_profile. However, clip cannot be accessed using dr_profile and see that this Error message was -10021 (CLIP_NOT_FOUND).
Description:
There are two CAS buckets under one namespace TEST.
dc_bucket
dr_bucket
There are two object users to have these buckets as default CAS bucket.
dc_profile has dc_bucket as default CAS bucket
dr_profile has dr_bucket as default CAS bucket
The below ACLs were configured.
dc_bucket: dc_profile -> Full, dr_profile -> Read and Read ACL
dr_bucket: dc_profile -> Read and Read ACL, dr_profile -> Full
After writing one object to ECS using dc_profile PEA, this clip can be accessed using dc_profile. However, clip cannot be accessed using dr_profile and see that this Error message was -10021 (CLIP_NOT_FOUND).
受影响的产品
ECS Appliance Hardware Gen1 U-Series产品
ECS Appliance, ECS Appliance Hardware Gen1 U-Series文章属性
文章编号: 000022400
文章类型: How To
上次修改时间: 01 3月 2023
版本: 5
从其他戴尔用户那里查找问题的答案
支持服务
检查您的设备是否在支持服务涵盖的范围内。