- Notes, cautions, and warnings
- Introduction
- Advantages of using Lifecycle Controller
- Benefits of using iDRAC with Lifecycle Controller
- Key features
- New in this release
- Advantages of using Lifecycle Controller Remote Services
- Licensable features in Lifecycle Controller
- About iDRAC RESTful API with Redfish and Web Service APIs
- About Lifecycle Controller API
- About one-to-many management achieved
- Other information that you may need
- Accessing documents from the Dell EMC support site
- Contacting Dell
- Remote Services Features
- Deployment and configuration
- Monitor
- Maintain
- Job management
- Getting started with API collateral and links
- Integrating the Lifecycle Controller API
- Social media reference
- Terms and definitions
Velkommen
Dell-websteder
Dell-websteder
Velkommen hos Dell
Min konto
- Afgiv ordrer hurtigt og nemt
- Se ordrer og spor status for din forsendelse
- Opret og få adgang til en liste med dine produkter
- Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Dell Lifecycle Controller Remote Services v2.60.60.60 Quick Start Guide
Collecting system inventory
When Collect System Inventory On Restart (CSIOR) is set to enabled, Lifecycle Controller performs an inventory and collects the configuration information for all hardware on every system restart. Also, the system inventory collection also detects any changes in hardware. If the Part Replacement feature is enabled and CSIOR detects that the managed hardware is replaced, Lifecycle Controller restores the previous configuration and firmware on the newly installed device based on the inventory collected during the previous system restart.
The CSIOR setting is enabled by default and it can
be disabled locally by using Lifecycle Controller or remotely with
RACADM, WS-MAN, or iDRAC RESTful API with Redfish. You can change the settings to one of the following:
- Enable—Hardware inventory and configuration information is collected on every system restart. Collecting system inventory may affect the boot time depending on the hardware present in the system.
- Disable—Hardware inventory and configuration information is not collected on every system restart. The usage of many features depends on the inventory information updates. Features such as Easy Restore and Part Replacement may not contain the latest information when CSIOR is disabled. In-band tools such as OMSA and DTK cannot configure BIOS when CSIOR is disabled. Also, system information reported from out-of-band interfaces such as WS-MAN, iDRAC RESTful API with Redfish, and RACADM may not have correct information.
Angiv vurderinger (1-5 stjerner).
Angiv vurderinger (1-5 stjerner).
Angiv vurderinger (1-5 stjerner).
Angiv, om artiklen var nyttig eller ej.
Kommentarer må ikke indeholde følgende specialtegn: <>()\