- Notes, cautions, and warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- System Overview
- Removing the SD Card
- Installing the SD Card
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Hard-Drive Assembly
- Installing the Hard-Drive Assembly
- Removing the Memory
- Installing the Memory
- Removing the Keyboard Trim
- Installing the Keyboard Trim
- Removing the Keyboard
- Installing the Keyboard
- Removing the Palmrest
- Installing the Palmrest
- Removing the SmartCard Reader Board
- Installing the SmartCard-Reader Board
- Removing the USH Board
- Installing the USH Board
- Removing the Finger-Print Reader Board
- Installing the Finger-Print Reader Board
- Removing the LED Board
- Installing the LED Board
- Removing the Power-Connector Port
- Installing the power-connector port
- Removing the WLAN Card / WiGig Card
- Installing the WLAN Card / WiGig Card
- Removing the WWAN Card
- Installing the WWAN Card
- Removing the Display-Hinge Brackets
- Installing the Display-Hinge Brackets
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display Panel
- Removing the Display Hinges
- Installing the Display Hinges
- Removing the Camera
- Installing the Camera
- Removing the eDP Cable
- Installing the eDP cable
- Removing the System Fan
- Installing the System Fan
- Removing the Coin-Cell Battery
- Installing the Coin-cell Battery
- Removing the System Board
- Installing the System Board
- Removing the Heatsink
- Installing the Heatsink
- Removing the Speakers
- Installing the Speakers
- System Setup Options
- Technical Specifications
- Diagnostics
- Contacting Dell
Dell Latitude E5250 / 5250 Owner's Manual
Installing the power-connector port
- Insert the power-connector port into its place on the computer.
- Place the metal bracket on the power-connector port and tighten the screw to secure the power-connector port to the computer.
- Flip the computer.
- Route the power-connector port cable to its routing channels and connect the power-connector port cable to its connector on the system board.
- Install the:
- Follow the procedures in After Working Inside Your Computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\